NestCut Back to the nesting studio

NestCut · Guide

How to Save Plywood and Acrylic: 8 Practical Nesting Tips

Sheet material is often the biggest cost in a cutting job, and the waste is mostly gaps between parts. Better nesting rarely means a magic setting; it means a handful of habits. These eight tips apply to plywood, MDF, acrylic and most other flat stock.

5 minute read · Last updated: 13 November 2026

1. Nest the whole job together

Parts nested alone on one sheet leave the same gaps every time. Put all parts of the same material and thickness into one run, so small parts can fill the spaces between large ones.

2. Allow rotation when the material allows it

Acrylic has no meaningful grain for most jobs, so allowing more orientations usually gives the nesting more options. Plywood and veneered boards often need parts aligned with the grain; in that case keep rotations at 1 or 2. See our grain direction guide.

3. Use the real usable sheet

Enter the area you can actually cut, not the catalogue size. If one edge is damaged or your machine cannot reach the last 10 mm, subtract it. A layout that does not fit the real sheet is worth nothing.

4. Keep spacing as small as your cutter allows

Every extra millimetre between parts is material you pay for. Measure your kerf, add a modest margin, and test. Spacing that is twice what you need can cost several percent of the sheet on a busy layout.

5. Add small filler parts

If you often make small items such as tags, keychains, test pieces or washers, keep a file of them. Adding a few of them to a job fills gaps that would otherwise be scrap, and gives you stock for free.

6. Try both packing directions

NestCut can pack from the bottom edge (Gravity) or from the top edge (Reverse gravity). The two can give different results for the same parts. Run both and keep the better one.

7. Clean up your outlines

Outlines with thousands of tiny segments are slower to nest and add no value at cutting scale. Simplify them in your design software and remove duplicate lines. Fewer, cleaner outlines make nesting faster and more reliable.

8. Compare results by numbers, not by eye

A layout can look tidy and still waste more than a messier one. Compare the material used, the waste and the pieces placed that the tool reports. Do not chase the last percent: a layout that is a little less tight but safe to cut is better than one that fails at the machine.

Common questions

Are bigger sheets more efficient? Often, but not always. A larger sheet gives the tool more room to combine shapes, so utilization can improve. Compare the cost per sheet with the material you actually save before changing suppliers.

What should I do with offcuts? Measure the useful ones and keep a short list. For small jobs, enter an offcut's size as the sheet size and nest the job there first. Reusing remnants is one of the cheapest savings available.

Does quantity change the result? It can. Many copies of the same part often pack better than a few, because identical shapes can be placed side by side. If you need 8 parts, check whether nesting 16 and cutting extras for stock gives a better sheet.

Keep reading

  • Grain Direction and Part Rotation in Nesting
  • What Is Kerf? How to Set Part Spacing for Laser, Plasma and CNC
  • How to Calculate Material Savings from Nesting (Worked Example)

See all guides

Try it on your own partsNestCut nests SVG outlines in your browser. New accounts start with 0 credits, and you earn credits by watching a short rewarded ad.Open the tool
© 2026 NestCut
ExamplesGuidesAboutPrivacy PolicyTerms of UseContact