NestCut Back to the nesting studio

NestCut · Guide

How to Calculate Material Savings from Nesting (Worked Example)

Nesting tools report a utilization percentage, but what does it mean for your costs? This guide explains the numbers and works through an example, so you can judge whether a better layout is worth the effort.

5 minute read · Last updated: 13 November 2026

The two numbers

  • Utilization: total area of the parts divided by the area of the sheet they use.
  • Waste: 100 percent minus utilization.

NestCut reports both after each run, together with the pieces placed. The part area counts the material actually left in the part, so holes inside a part do not count as used material.

A worked example

Take a sheet of 1200 mm by 600 mm. Its area is 720,000 square millimetres. Suppose your parts together have an area of 540,000 square millimetres.

  • Utilization = 540,000 divided by 720,000 = 75 percent. Waste is 25 percent.
  • A better layout of the same parts reaches 82 percent. The parts still have 540,000 square millimetres, so they now need 540,000 divided by 0.82, or about 658,500 square millimetres of sheet.
  • That is about 91 percent of the sheet, so you use roughly 8.5 percent less material for the same parts.

What that means in money

As an illustration only, suppose a sheet costs 900 rupees and you cut 100 sheets' worth of parts a year at 75 percent utilization. That is 90,000 rupees of material. Reaching 82 percent saves about 8.5 percent of it, close to 7,700 rupees a year. These figures are an example, so use your own sheet price and volume.

Savings add up fastest on expensive material such as thick acrylic or metal, and on jobs you repeat.

Why 100 percent is not realistic

Parts have curves and corners, and kerf spacing must stay between them, so some gaps always remain. How much is achievable depends heavily on the shapes: rectangles can pack very tightly while irregular organic shapes cannot. Compare layouts of the same job rather than comparing different jobs.

Spacing is a trade-off

Larger gaps between parts lower utilization. Use the smallest spacing that gives a clean cut on your material, as described in our kerf guide. Re-running the same job with slightly different spacing, rotations and packing direction, and keeping the best result, is the simplest way to improve.

Common questions

Does utilization include the space lost to kerf? Kerf and the gaps you set between parts are not counted as used material, so more spacing lowers utilization. That is why choosing the smallest safe spacing is the easiest way to improve it.

How do I compare layouts that use different numbers of sheets? Look at the total sheet area each one needs, including the partly used last sheet. If the last sheet is mostly empty and the offcut is large enough to reuse, that remnant has real value, so consider it when comparing.

Is it worth chasing one more percent? Only if the material is expensive or the job repeats. For a one-off cut in cheap board, a safe layout that you trust is worth more than a marginal gain.

Keep reading

  • How to Save Plywood and Acrylic: 8 Practical Nesting Tips
  • What Is Kerf? How to Set Part Spacing for Laser, Plasma and CNC
  • How to Nest SVG Parts for Laser Cutting, Step by Step

See all guides

Try it on your own partsNestCut nests SVG outlines in your browser. New accounts start with 0 credits, and you earn credits by watching a short rewarded ad.Open the tool
© 2026 NestCut
ExamplesGuidesAboutPrivacy PolicyTerms of UseContact