NestCut · Guide
What Is Kerf? How to Set Part Spacing for Laser, Plasma and CNC
Kerf is the width of the material that disappears when your cutter passes through the sheet. A laser beam, a plasma arc, a waterjet and a router bit all remove a slightly different amount, and that difference decides how far apart your nested parts need to be and how accurate your finished parts are.
6 minute read · Last updated: 13 November 2026
Typical kerf by cutting method
The numbers below are typical ranges only. Your machine, nozzle, speed, power and material change them, so always measure your own.
- CO2 laser on thin wood or acrylic: often a few tenths of a millimetre, commonly around 0.1 to 0.3 mm.
- Plasma: usually much wider, often in the range of 1 to 3 mm, and it grows with material thickness and nozzle wear.
- Waterjet: often around 0.5 to 1.5 mm depending on nozzle and abrasive.
- CNC router: the diameter of the bit. A 3.175 mm (1/8 inch) bit removes a path 3.175 mm wide.
- Knife or vinyl cutter: close to zero kerf, but blade offset and corners still matter.
Why kerf matters twice
First, it affects part size. If the cutter follows the exact line you drew, the cut removes material equally from both sides of the line, so an outside cut makes the finished part smaller than drawn by about one kerf in each direction. Second, it affects spacing. Two parts placed with no gap would have their cuts run into each other, and the thin strip between them may burn through or break.
How to measure your kerf
- Draw a square of a known size, for example 50 mm, and cut it from the same material and thickness you will use.
- Measure the finished square with calipers.
- Kerf is roughly the drawn size minus the measured size.
- Repeat on a second piece to confirm. Write the result down for each material and thickness.
Choosing the space between parts
Spacing should be at least the kerf, plus a safety margin for heat and for the strength of the strip left between parts. As a starting point:
- Thin laser jobs: kerf plus about 1 mm is a common starting point.
- Thick wood or acrylic: increase the margin, because heat marks and flare-ups spread further.
- Plasma and waterjet: use at least the kerf plus a margin of about one material thickness, and test.
These are starting points, not rules. A few test cuts will tell you what your setup needs.
Setting it in NestCut
In the settings, enter your value under Space between parts. NestCut keeps that gap between neighbouring parts. It does not change the size of the parts themselves: if you need the cut path moved outward or inward to compensate for kerf, do that in your cutter's software.
More spacing means lower material use, so do not set it larger than you need. The trade-off between a clean cut and a tight layout is yours to decide for each material.
Common mistakes
- Using the same spacing for every material and thickness.
- Forgetting that plasma kerf grows as the nozzle wears.
- Measuring kerf on a different material from the one you cut.
- Setting spacing to zero and expecting clean separation.
Common questions
My cutting software compensates for kerf. Do I still need spacing? Yes. Compensation moves the cut path so the part comes out at the right size. Spacing is about the strip of material left between two parts, which must be strong enough and must not overheat. You usually want both.
What about holes? Kerf works the other way for inside cuts. If the cutter follows the drawn line, a hole comes out larger than drawn by about one kerf, while the outside of a part comes out smaller. For parts that must fit together, such as slots and tabs, measure both and adjust the drawing or the compensation.
Is kerf the same in every direction? Not always. Focus, speed, corners and machine condition can change it, so measure along both axes on the same material and thickness you will cut, and keep the larger value when in doubt.